久久久久亚洲AV成人无码-国产美女久久精品香蕉69-国产综合久久久久久鬼色-久久这里只有精品18-亚洲女久久久噜噜噜熟女

行業新聞

當前位置:首頁 > 新聞中心 > 行業新聞

簡要了解制氧機制取氧氣的主要方法有哪些

來源:http://m.xingchangweb.com/   日期:2021-08-26   瀏覽量:0
TAG:山東制氮機,山東干燥機,山東螺桿鼓風機,山東空壓機,山東自動排水器
一、膜分離法利用一些有機聚合膜的滲透選擇性,當空氣通過薄膜(0.1um)或中空纖維膜時,氧氣穿透過薄膜的速度約為氮的4-6倍,從而實現氧氮的分離。
1、 Membrane separation method uses the permeability selectivity of some organic polymeric membranes. When air passes through the membrane (0.1um) or hollow fiber membrane, the speed of oxygen passing through the membrane is about 4-6 times that of nitrogen, so as to realize the separation of oxygen and nitrogen.
這種方法裝置簡單,操作方便,啟動快,投資少。但它的氧濃度比較低,一般在28%-35%,所以它一般應用在氧氣純度不算高的地方。
This method has the advantages of simple device, convenient operation, fast start-up and less investment. However, its oxygen concentration is relatively low, generally 28% - 35%, so it is generally used where the oxygen purity is not high.
山東制氮機
二、電解法采用的原理是在稀的硫酸、氫氧化鈉或硫酸鈉的水溶液中通直流電,使水電離。每制取1m3氧氣,同時獲得2m3氫氣。但由于制取1m3氧氣耗電量為12-15度耗電量太大,這種方法也不能大量生產。
2、 The principle of electrolysis method is to apply direct current in dilute sulfuric acid, sodium hydroxide or sodium sulfate aqueous solution to ionize water. Every 1m3 of oxygen is produced and 2m3 of hydrogen is obtained at the same time. However, because the power consumption for preparing 1m3 oxygen is 12-15 degrees, the power consumption is too large, and this method can not be produced in large quantities.
三、變壓吸附法分子篩式制氧機是一種氣體分離。物理方法(PSA法)直接從空氣中提取氧氣,即制即用,新鮮自然。在制氧機中裝填有分子篩,每克分子篩的表面積能達到800-1000m2/g,在加壓的情況下,利用分子篩的物理吸附和解吸,吸附空氣中的氮?dú)?,未被吸附的氧氣則會被收集起來,通過對其進行凈化處理,就能夠得到純度比較高的氧氣。分子篩制氧機是目前成熟的,具有標準和標準的制氧機,可實現周期性的循環制氧,是一個動態的過程不存在高壓易爆等危險。
3、 Pressure swing adsorption molecular sieve oxygen generator is a kind of gas separation. Physical method (PSA method) directly extracts oxygen from the air, which is ready to use, fresh and natural. The oxygen generator is filled with molecular sieve, and the surface area of each gram of molecular sieve can reach 800-1000m2 / g. under pressure, nitrogen in the air is adsorbed by physical adsorption and desorption of molecular sieve, and the non adsorbed oxygen will be collected. Through purification treatment, oxygen with high purity can be obtained. Molecular sieve oxygen generator is mature at present. It has standard and standard oxygen generator, which can realize periodic circulating oxygen production. It is a dynamic process without high-pressure explosion and other risks.

上一篇:螺桿空壓機故障警聲響起的原因分析!
下一篇:如何能制氮機純度下降的問題

久久久久亚洲AV成人无码-国产美女久久精品香蕉69-国产综合久久久久久鬼色-久久这里只有精品18-亚洲女久久久噜噜噜熟女